Problems encountered by UV curing equipment in the whole process of adhesive drying
The size of the total area of the UV curing machine is judged according to the model and specification. Generally speaking, the light wave length of the commodity is different, which results in the different dimensions of the direct total area, which cannot be generalized.
1. The new lamp is not on or the operating voltage of flashing lamp 1 is too high, and the transformer is not in conformity
2. The output power and the main parameters of lamp 1 are measured accurately. The deformation of lamp 1 equipment is poor in evaporation cooling, and the surface temperature of 2 is too high. The air cooling system software of equipment is improved
3. The lamp oil current is too high, and the surface of the lamp is stained or splashed under high temperature
5. Virtual connection, short circuit fault and large lamp current of UV curing equipment make transformer load operation accurately measured
6. Power supply voltage mismatch remove lamp, bulb, transformer and electronic ballast
7. Pay attention to the surface cleaning of lighting lamps, too high color of lamps, matching of transformers
8. High working pressure, power supply voltage more than 10%
9. The equipment around the equipment is ventilated naturally, reducing the input voltage and improving the natural ventilation
10. Remove equipment around the natural environment
11. The current of the neck is too high or the power socket of the bulb is removed and replaced
12. The air cooling of one equipment is not good and the surface temperature is too high to improve the software of air cooling system of equipment
